Schematic for how front bumper cover attaches

[violaGT3]

Picked up I believe all the screws for the front bumper cover as there were a few missing, but there are 2 T shaped metal brackets at the bottom edge and I do not know how they are incorporated and the PET diagram I have doesn't show it? TIA

[Loren]

Help us out here... model car? year? standard front bumper or aerokit or 3rd party?

[violaGT3]

exactly like yours, I believe, Aerokit II, 99 C2 Coupe, all factory. :D

[Loren]

Mine is an Aerokit Cup bumper (my aerokit is factory).

I don't remember any metal T-shaped pieces for the bumper... maybe part of the radiator support brackets?

You can find the diagrams and photos in my 3rd radiator DIY here.

[violaGT3]

Oops sorry maybe thats what mine is called too? any ways here is some pics to further help. It looks like it is a factory setup. I cannot locate the part in the schematic either?

P.S. excuse the dirt it's been underconstruction for the past week and a half :(

Edited February 9, 2006 by ViolaGT3

[Loren]

It looks like part of your wheel well lining is missing including the rubber lip that hangs down and the air duct for the brakes. Look at the wheel well lining diagrams and make all the parts are there. As I recall all of those items are held in place by a long self tapping screw that attaches to the bottom of the radiator bracket.

[violaGT3]

It looks like part of your wheel well lining is missing including the rubber lip that hangs down and the air duct for the brakes. Look at the wheel well lining diagrams and make all the parts are there. As I recall all of those items are held in place by a long self tapping screw that attaches to the bottom of the radiator bracket.

Hey Loren, you are right the hang down diffuser is missing, well most of it. My ground clearance is about 2.5 inches so I know why they are not there. It seems as though the rest is there except a un identifiable stud that a self threading nylon nut goes on to hold the well liner in place it is noted to be directly behind where the turn signal snaps in. I see a hole but not a stud nor where a stud could of possibly been? The Porsche liner schematic shows the nut but not the studs whereabouts. So can anyone identify the stud or bolt that is supposed to be here? TIA