Airbag Light On, need help with the code

[Spoon]

Hi, My airbag light recently came on and I was able to pull the codes. But the information isn't too helpful. I searched the internet, the results were mostly in Audis, They have similar codes. I am wondering if the members here could help me decipher what these messages mean. Thx

Car is 14 CTTS
 

Edited October 1, 2021 by Loren
Made image viewable...

[Loren]

I am not sure what Durametric is showing there. 

All 92A Cayenne's (2011 - 2018) airbag codes start with B.

 

[Spoon]

Hi Loren.

I am buying a different reader to pull the code. hopefully I will get the correct information. Will report back. Thank you

[Spoon]

With a different scanner. I was able to get.

B10001B - Driver Airbag stage 1, Limit Value Exceeded

B10011B - Driver Airbag stage 2, Limit Value Exceeded

hopefully this helps

[Loren]

B10001B - Driver's airbag

 

Possible fault causes:
- Coding Ignition circuit is connected and OK, but is not coded.
- Electrical fault in circuit Electrical connection between two ignition circuits (mutual short circuit). Short circuit in wiring harness of two ignition circuits
- Short circuit to B+/ground/between lines or open circuit in the lines
- Limit exceeded This fault is recognized if the angle measured between >control unit and igniter< deviates from the specified value.
- Below limit This fault is recognized if the angle measured between >control unit and igniter< deviates from the specified value.
- Deactivated The ignition circuit is deactivated, because the wear/age limit was reached.
- A triggering event (accident or similar) has occurred.

 

B10011B - Driver Airbag

 

Possible fault causes:
- Coding Ignition circuit is connected and OK, but is not coded.
- Electrical fault in circuit Electrical connection between two ignition circuits (mutual short circuit). Short circuit in wiring harness of two ignition circuits
- Short circuit to B+/ground/between lines or open circuit in the lines
- Limit exceeded This fault is recognized if the angle measured between >control unit and igniter< deviates from the specified value.
- Below limit This fault is recognized if the angle measured between >control unit and igniter< deviates from the specified value.
- Deactivated The ignition circuit is deactivated, because the wear/age limit was reached.
- A triggering event (accident or similar) has occurred.