Need wire schematic for low beams on a 03 S

[shastamonk]

Does anyone have a wire schematic for 03 S low beam headlights? My passinger side (LHD) is flaky. I already replaced the switch and bulb. I suspect the relay may be bad.

Regards,

Scott

[Loren]

Check the connector inside the fender. I have seen the wire connectors push out and broken connectors.

[shastamonk]

Check the connector inside the fender. I have seen the wire connectors push out and broken connectors.

Loren, I pulled the inner fender off and made sure the plug was seated with the clip removed.

Regards,

Scott

[Loren]

You have tried switching the bulbs from one side to the other to see if the problem follows the bulb - right?

[shastamonk]

You have tried switching the bulbs from one side to the other to see if the problem follows the bulb - right?

Yes, I switched the bulbs and the problem remained the same.

[juniinc]

Have U checked the fuse A9?

also check your relay HCS F28

If those are fine,,,,

this is based on a 2000 diagram.

0.75 BK/GN-turn signal HOT+.

0.75 GR/RE-side marker HOT+.

1.5 WT-high beam HOT+.

2.5 BR-ground

1.5 YE/WT-fog light HOT+

1.5 YE-low beam HOT+

1.5 BR-ground low beam.

-I would get a multi or 12V meter,

-remove passenger Headlight,

-engage switch,

-measure between YE-low beam HOT / BR-ground,

that should give U a good point to trouble shoot.

Good luck.

Edited August 7, 2009 by juniinc