Distance between PDC sensors and height Post 03 bumper

[jpcolin]

I'm planning to retrofit the PDC system but I would like to know the positon of the OEM sensors.

so if someone has the PDC on a boxster could you please measure the distance between the 2 center sensors en between the 2 right or left sensors. Also the distance between the sensors and the lower line of the bumper, so I know where to drill my holes.

thanks

[Tool Pants]

For some reason I have in the back of my mind that the locations are marked inside the cover. If your cover is off take a look.

[jpcolin]

Hi TP,

Is this the case for a bumper without the PDC option?

thx

[Tool Pants]

I dont think there is a bumper just for the park assist option. I just looked at the shop manual and it says there are markings for where to drill the holes for the sensors. Pull your bumper off and look.

[jpcolin]

TP, I just looked in the partcatalog and there is a different bumper M635 option (PDC)

For the -03 also.

In which section did you looked in the boxster shop manual?

[Tool Pants]

I did not look in PET - it was from my memory.

Then I looked at the shop manual, and it is there. What a memory....

When I get a chance I'll have to see what PET says.

[jpcolin]

I'm think this is for the pre 03 model, not sure it's the same for the post 03

[Loren]

Correct, as of MY03 Boxster ParkAssist gets it's own bumper.

[jpcolin]

so no marking on the standard bumper I guess?