Welcome to RennTech.org Community, Guest
There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.
Here are some of the features available - once you register at RennTech.org
- View Classified Ads
- DIY Tutorials
- Porsche TSB Listings (limited)
- VIN Decoder
- Special Offers
-
OBD II P-Codes - Paint Codes
- Registry
- Videos System
- View Reviews
- and get rid of this welcome message
It takes just a few minutes to register, and it's FREE
Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)
- No ads - advertisements are removed
- Access the Contributors Only Forum
- Contributing Members Only Downloads
- Send attachments with PMs
- All image/file storage limits are substantially increased for all Contributing Members
- Option Codes Lookup
- VIN Option Lookups (limited)
Leaderboard
Popular Content
Showing content with the highest reputation on 09/06/2023 in all areas
-
The online manuals show the layout of the servos in chapter HVAC.pdf, from about page 35 on. These diagrams provide adequate information on positioning of the servos for re-installation. It doesn't matter where they are for removal. You can adjust the arms on your bench with a small 12v power source and a couple of leads. Contacts 1 and 2 can be teased to operate the servo motor. Reverse the contacts to reverse the motor until you have each in the position it's shown in the diagram. Then positioning of the servos becomes the least of your problems. Don't start the job without a set of long torqx screwdrivers and a tiny ratchet with assorted torqx bits. My experience in replacing the servos on a 2004 CS with left hand drive may not translate directly to a car with right hand drive, but I wrote about it at https://rodcroskery.wordpress.com/category/2004-porsche-cayenne-review (reverse chronological order September 18, 2016) and posted comments on page one of this discussion.1 point